6D UV Liquid Tempered Glass Screen Protector For Apple Watch

Giới thiệu 6D UV Liquid Tempered Glass Screen Protector For Apple Watch

Features:
100% Brand new and high quality
9H hardness,HD Clear Tempered Glass Film
Material: Tempered Glass
First released 6D curved edge:It's truly unique full-screen overlay with 6D curved edges, perfectly bonded to your iWatch series, providing 360-degree protection and easy application
Premium Tempered Screen Protector: After the glass material steel processing, hardness up to 8-9H. Profeesional surface finish processing, smooth & comfortable touch feeling, only 0.3mm thickness, but high impact resistance, anti-scratch
High Defintion: More than 98% transmittance of light transmission rate level, it does not weaken the brightness of your iwatch, low reflection ,high transparency
High Sensitivity: Ultra-thin thickness ensure a real and super smooth touch experience.
Compatible With:
For Apple Watch Series 3/2/1 (42mm)
For Apple Watch Series 3/2/1 (38mm)
For Apple Watch Series 4 (40mm)
For Apple Watch Series 4 (44mm)
Package included:
1 x Tempered glass screen protector
1 x UV Glue
1 x UV Light
It should take more patient to install the glass protector:
Step 1 : Clean the screen with the wet wipe and cloth and removing any case from you watch
Step 2 : Stick the key hole with a label,and then use a knife or scissor open the liquid adhesive box,drop it on the screen(It is recommended that the glue be poured completely.The glue that drops on the screen can't have air bubbles, if there is air bubble, use the needle to pierce the air bubble to let go air. )
Step 3 : Peel off the mask film from the glass,then place the screen protector to a suitable position on your device SLOWLY. PLEASE DO NOT LIFT AND PRESS THE GLASS TO LET THE ADHESIVE SPREAD,JUST LET IT AUTOMATIC DISPERSION.(Very important)
Step 4 : Wait for about half a minute to let the adhesive spread and level.
Step 5 : If the adhesive overflow, wipe off with a clean cloth. After checking the retention criteria for the watch's tempered film, the lamp was turned back and forth several times around the edge of the phone, and after 3 seconds of initial curing (not in the middle), the edge glue was wiped again until the glue overflowed. (Prevent white edges or long bubbles on edges)
Step 6 : Wait for the exhaust to complete, after the glue overflows cleanly, after the positioning standard of the tempered film is satisfied, turn on the light. Otherwise scrapped material.
Step 7 : Irradiate the watch under UV lamp and need to illuminate twice for about 3 minutes to reach the fully-cured position.
Step 8 : Clear the screen,and turn off the UV lamp for reuse.
Giá FROG